how to remtoely connect to MAS??

[TDMorIP]

Can use RAS and connect to it , but how do you RDP over to teh MAS. cant even ping it..

 

[texeric]

You might not be able to ping it but if you RAS into it you should be able to RDP to the Corporate IP of the MAS you remoted into.

http://www.theviagroup.com

 

[TDMorIP]

yes im connected just like i connect to CM RAS connections (needed domain) but i cant rdp to it. anything else needed on the MAS??

 

[texeric]

Depending on the version remote desktop should already be enabled. remote desktop should be enabled on each server that you need to RDP into. You cannot connect to your CM RAS and then RDP from there to any MM server. You have to be connected to the RAS on the server you are trying to RDP into.

http://www.theviagroup.com

 

[TDMorIP]

i am using RAS to the MAS i was just asking if the RAS connection needed to be setup just like CM connections. it does connect but i cant RDP...maybe its just not enabled on the MAS for RDP connectins? RDP is the only way of getting to it, correct?? thanks.

 

[texeric]

RDP is the only way of getting to the MAS. It is possible the MAS was not (or was changed from) enabled for remote desktop. The only way I know of to configure it is from the console of the server itself. Not sure of a way to remotely enable it (if that is even possible).

http://www.theviagroup.com