How to remove DTI Loop from CFN

[penduko]

I have 1 loop configured for DTI/PRI card from one of our option11 and want to remove that from the loop configuration and replace it by a TDS. Any information will be helpful for a Nortel newbie like me.... Thanks....

 

[PERRYPJ]

YOU NEED TO REMOVE ALL ASSOCIATED PROGRAMS CHANNELS, DCH'S THEN YOU CAN GO INTO LD 17 AND GO TO DLOP AND X(LOOP #) OLD ROLMEN WORKING ON NORTELS

 

[penduko]

Thanks....

 

[Jumpermonkey]

Perrypj, I just posted a new request for this same info.
(I didn't check the previous posts first)
Can you elaborate on removing all channels, dch, etc.?
Our class has a TMDI card programmed as a DTI with one Tie Trunk on it. It goes from one student booth to another, so there's not too much programming to delete.
I used to be a ROLMAN also in San Francisco.

Thanks in advance!
JumperMonkey

 

[PERRYPJ]

START WITH DELETING THE TRUNKS, IF YOU HAVE NO DCH INVOLVED GO AHEAD DISABLE THE T1 IN LD 60 IN GO TO LD 17 AND GO DOWN TOO YOU GET TO DLOP. TYPE X AND THE LOOP NUMBER THIS WILL OU THE T1

OLD ROLMEN WORKING ON NORTELS