Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to "Unset" CATOS

Status
Not open for further replies.
jkaftan

jkaftan

MIS
Apr 8, 2005
81
US
Hi:

I have two switches running CatOS and I want to get rid of some of the set commands. I remember using the unset command at a former shop in CATos. However I see no way to negate set commands on this switch. I cannot use unset nor can I use no.

Any ideas?
 
Sort by date Sort by votes
jkaftan ,

Know just a little on CATOS - Found this in Google:

All configurations in CatOS are done via a “set” command sequence, executed from the enabled-mode prompt.

The clear command from the same prompt will erase a particular command.


Hope it helps!


E.A. Broda
CCNA, CCDA, CCAI, Network +
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

woza
  • Locked
  • Question
GNS3: Delete the lines "transport preferred none"
Replies
1
Views
503
DrB0b
DrB0b
Skip Rango
  • Locked
  • Question
how to backup cisco sg500-52p switch
Replies
1
Views
549
madwok
madwok
B
  • Locked
  • Question
Cisco IP phone 7841 8851 unable to forward all to external number
Replies
0
Views
197
badwolf1686
B
CPM86
  • Question
Cisco isr 4331 with IOS and sip busy fail over to 2nd sip number on pbx?
Replies
0
Views
170
CPM86
CPM86
Luzbel
  • Locked
  • Question
Connecting HVAC controller to network
Replies
0
Views
386
Luzbel
Luzbel

Part and Inventory Search

Sponsor

Back
Top