How to modify outgoing A-number? 1

[JonasK]

Hi,
I want to archive the following functionality:

By dialling one out of ten different prefixes before the B-number I want to be able to choose which, in a list of ten, A-number that should be presented on the terminating side.

We have a MD110, BC12, which is connected to another PABX (Avaya) via public ISDN-trunks. I have been told that it should be possible to choose the sent A-number by dialling a prefix before the B-number that I want to reach in the terminating PABX. The calls should be sent over the same physical trunk.

I’ve looked in the documentation and the only thing a can come up with as a solution is to create ten different destinations (RODDI) and then use number conversion (NUTRI:CNVTYP=1,TARDST=xxx…..) to perform a A-number conversion for each destination. I haven’t been able to test this yet so I do not know if it will work.

Is there any other way to create this type of functionality?

Best regards
/Jonas

 

[mundus]

Use NUTRI:CNVTYP=1,TARDST=xxx… and in the RODDI, for the dest, set d24=1.

 

[JonasK]

It worked just fine! Thanx for the hint regarding ADC d24!
/Jonas