Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to make vertical lines end with details

Status
Not open for further replies.

foru11

MIS
Aug 25, 2011
38
MY
Hi,

I am using CR10, Oracle 11g.

I am facing a problem with the vertical lines going till the end of the page. There are more details at next page. I would like the vertical lines to end at the horizontal line but I have no luck in solving this problem. (You may refer to attachment for clearer understanding).

In this report, there is a grouping by customer number and page break by this group. The horizontal line is putting at the details section because I need to have line for each record. The vertical lines I draw until GF1.

I really no ideas how to solve this problem.
Please help and thanks in advanced.
 
Did you try ending the vertical line in the Details section itself just where it touches the horizontal line
 
I would both start and end the vertical line in the details band. Go into "Size and Position" to set the position to zero so it touches the top. Go int Format Line and check "Extend to bottom of section" to make sure it touches the bottom. The horizontal line can also be set to move to the bottom of the section which will help if the section every has to grow.

Ken Hamady, On-site Custom Crystal Reports Training & Consulting
Public classes and individual training.
Guides to Formulas, Parameters, Subreports, Cross-tabs, VB, Tips and Tricks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top