Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to integrate with Netware 3.12 and IBM NAS226?
- Thread starter mikesu
- Start date
If you haven't bought it, don't. It would work, but it would be difficult. Look into a SAN instead.
This may be what you actually looking for. I search around IBM's support site on NAS and all they tell you is that it would work, not how you get it to work. If you go with a NAS, then be ready to call support.
The only pain part with the IBM SAN is the initial configuration you have to use a serial connection to add an IP address to the RAID card so you can set it up. The manual tells you you need to do this, but they don't tell you how to do it.
Brent Schmidt CNE,Network +![[atom]](/data/assets/smilies/atom.gif "[atom] [atom]")
![[rofl]](/data/assets/smilies/rofl.gif "[rofl] [rofl]")
This may be what you actually looking for. I search around IBM's support site on NAS and all they tell you is that it would work, not how you get it to work. If you go with a NAS, then be ready to call support.
The only pain part with the IBM SAN is the initial configuration you have to use a serial connection to add an IP address to the RAID card so you can set it up. The manual tells you you need to do this, but they don't tell you how to do it.
Brent Schmidt CNE,Network +
- Status
Similar threads
- Locked
- Question
- Locked
- Question