How to install crashed OS Hipath 4000 V3

[Hamid2018]

Dears

Hi,
By use of this thread965-1744332 I am trying to install a clean installation of hipath 4000.

I have ping of 192.0.2.3 in less than 1ms and firewall is completely off but when I test the connection in pchi tool V2.13 in special DSCXL Connection -> standards-DSCXL (duble tap and load it)and press test, but the system answers no connection to computer 192.0.2.3!

I skipped this step and went forward and Operating system installed as simplex comwin connection were available but the CCB wasnt get to state S and repeatedly restarting.

after some moments ADP started to repeatedly restart every 10 minutes.

What Should I do to make a clean installation of Hipath 4000 V3 Duplex?

(the problem is that the server doesn't load properly with its old HDD but by inserting an other hipath 4000 V3 hdd it loads but does not working properly as it has errors on its ansu (answeringto dis-ansu;

S48: START OF AMO ANSU NOT SUCCESSFUL
CAUSE : AN INCONSISTENCY IN YOUR CONTRACTED SW HAS BEEN DETECTED )

Since I have an other System V4 CF flash disk and an spare HDCF board is it possible to load system with an other systems CF card and change anum and enter the original systems codew?

Best Regards
Hamid

 

[donb01]

I would try DIS-CODEW; from comwin and see if it considers your codeword valid for your system configuration. You might have to re-enter the correct codeword, but it should still run in trial mode for 30 days either way, unless your trials are used up.

Don Bruechert, Voice Comm Analyst II
CareTech Solutions @ Holy Family Memorial
Manitowoc, WI, USA

 

[Hamid2018]

I found the problem it was SETTIMEDATE.CBL.

it was hinted in Thread965-1744332 but I didn't get it ( it was under .Macro stard CBL
so system didnt accept ADD-ANSU AMO...

Thank you so much
Hamid