I need to replace a DSP daughterboard on one of my G430 Media Gateways. I have no active TDM or analog interfaces, or any VAL announcement groups on this unit, only DSP resources. Is there a command to gracefully shut down the DSP use on the gateway, as I still have some use of the onboard DSP.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to gracefully busyout a Media Gateway DSP usage
- Thread starter curtismo
- Start date
Well, you're not swapping a G430 DSP without taking the case off. And you're not swapping a G450 DSP without putting out the mainboard from the backplane.
So, no
They might be broken down into smaller chunks in the gateway itself so you can test calls through different parts of the DSP, but you're not swapping them without pulling power to the box!
So, no
They might be broken down into smaller chunks in the gateway itself so you can test calls through different parts of the DSP, but you're not swapping them without pulling power to the box!
montyzummer
IS-IT--Management
If you are worried about active calls campon busyout voip-dsp x from the cli of the gateway.
APSS (SME)
ACSS (SME)
ACIS (UC)
APSS (SME)
ACSS (SME)
ACIS (UC)
- Status
Similar threads
- Question
- Locked
- Question