How to get multiple appearances of one target line on one set? 1

[johnathcc]

I've seen this done, so I know it's possible, but how do you do it? Five appearances of one line on one set, like this:

Button 10: Line123, 5551234
Button 11: Line123, 5551234
Button 12: Line123, 5551234
Button 13: Line123, 5551234
Button 14: Line123, 5551234
Button 15: Line124, 5551235
Button 16: Line125, 5551236

These are target lines in a PRI/DID environment on an MICS.

Thanks,

John Kelly

 

[bkrike]

T&S/line access/appearances

 

[johnathcc]

That's how you get one appearance on the set. How do you get four more of the same line on the same set?

 

[bkrike]

You are incorrect.
I suggest you call a qualified vendor.

 

[galfaro]

John,
This really is a simple set up.
Are you familiar with Norstar?
Or better yet, is there a reason why you wouldn't have your vendor come do this for you?
Gabriel

 

[skippy440]

When you assign a target line to any extention, you can assign how many appearances you want of that target line.

The system will default the number of appearances to 1 unless you use the change button to increase the number.

In order to move these lines to the non default buttons after updating the ksu programming, you can use F*81.

 

[jerryreeve]

terminals & Sets->line access->line assignment->show line(the next step only shows up if the line has been set)->appearances.

this was on a MICS 4.1

If voting could really change things, it would be illegal.

JerryReeve
Communications Systems Int'l
com-sys.com

 

[BagsNYC]

I agree with galfaro. This would be 15 mins for a qualified vendor..