How to find your RAID Level?

[theripper]

Just started a new position.&nbsp;&nbsp;We have an NT Server that was setup 'bout a year ago.&nbsp;&nbsp;The consultant left NO documentation of hardware, config, etc. . . .&nbsp;&nbsp;I'm trying to figure out what RAID level we currently have.<br><br>In DiskManager - It shows one drive (C as 8Gb.&nbsp;&nbsp;Looking at the front of this HP NetServer LC 3, you can see three (3) 4 Gb drives looking right at you.<br><br>From the bill of sale, I can see that an HP NetRAID-1 Disk Array Controller was installed.&nbsp;&nbsp;But, I didn't know if THAT meant RAID Level 1 or not.&nbsp;&nbsp;Do I need to run a specific HP software to find out?<br><br>Any suggestions would be greatly appreciated!<br><br>Thanks in advance ~

 

[dxd]

If all Diskmanager shows is a 8gb drive then I would assume HW Raid5 has been implemented. <br><br>You should use the HP Array configuration utility to verify.<br><br><br><br>dxd

 

[theripper]

Thanks dxd!