How to find wiring pair outputs on a 2wire digital card G3siV6 2

[chris5225]

Hi everyone and thanks in advance for your help.
How do i find the pair to add a sta on a g3siv6 2wire digital card. In other words i want to make sta xxx (already existing from analog to digital)
what do i need to do in the switch to find out what pairs are already working off the 2wire digital line crd and what pair do i use inn add sta??
thanks
chris

 

[chris5225]

Hi
what I ment to day is how to find out what pairs are in use on the 2wire digital line card and how manny are available of the original 18??
thanks chris

 

[wellco9530]

Chris....It depends on what card you are using i.e: TN 2181 is a 16 port and a TN 2224 is a 24 port...
So you will need to figure that out first, then do a "list config board xxxx" and see what port is available and then you can use that port...assign your station to that by doing "change station xxxx"
Then if it's a TN 2181 the 16 ports layout a little wierd start with the BL/W pair (port 1) first 4 pairs then skip 4 pair then the next 8 pair are ports then skip 4 then the next 4 pair are ports again....with the last port being the V/BR (port 16)
On the TN 2224 its the the first 24 pair again ending with the V/BR pair....

Good Luck

...bob...

 

[chris5225]

Hi Bob and thanks it is a TN2214B circuit pack
Thanks again
chris

 

[Midstream]

Here's a good visual reference to what Bob has described..

See page 17

http://support.avaya.com/css/P8/documents/100015139

The Communication Manager command "list config station" will show used/unused ports to compare against your punchdowns as well.

 

[wellco9530]

TN2214B is tied down same as a TN 2224.....

...bob...