I have a problem where occasionally one of my pty ports is getting locked out - OVL 400 TTY 11 30. But when I issue the WHO command it only shows my connection on a physical TTY port. When you stat in 37 you see the pty port enable then after about 5 secs it disbales again, then enables and so on.
I have also used pdt command rloginShow but his shows no active sessions.
System = CS1000e
Software = 4.50
If there are any additional commands or ideas on how to trace this would be much appreciated
Thanks
I have also used pdt command rloginShow but his shows no active sessions.
System = CS1000e
Software = 4.50
If there are any additional commands or ideas on how to trace this would be much appreciated
Thanks