I have a 3com Corebuilder 9000 and I cannot get the 10 Base T port on the management module to work. I know that it takes a cross over and that is not the problem.
I know that it was working at one point but I was in there messing around with stuff. It has software 3.0.0 on the unit and I want to get it to 3.0.5. I have a 9300 and a few 3900's and upgrading the software on them has been really easy. I would send it to 3COM but I have to have the CB for a LAN party on the 17th and 18th of April. Right now the unit showes up as a "cloud" in the 3com Networking software. With the new software it will show up like the other switches that I have. I really want to be able to watch the badwith on all of the units.
I know that it was working at one point but I was in there messing around with stuff. It has software 3.0.0 on the unit and I want to get it to 3.0.5. I have a 9300 and a few 3900's and upgrading the software on them has been really easy. I would send it to 3COM but I have to have the CB for a LAN party on the 17th and 18th of April. Right now the unit showes up as a "cloud" in the 3com Networking software. With the new software it will show up like the other switches that I have. I really want to be able to watch the badwith on all of the units.