Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to duplicate a bootable tape ?
- Thread starter forhad
- Start date
tcopy should do the job for you!
You can try dd as well!
Have a look into this link:
Regards,
Khalid
You can try dd as well!
Have a look into this link:
Regards,
Khalid
I've been in this situation before with only a single tape drive and it was on 4.3.x as well.
As root, I created a temp directory and cd'ed into it.
I dd'd from device /dev/rmt?.1 to a file with a sequence number (i.e.: of=./file#) which reads until end of file but does not rewind.
I do this continually until a read error (at EOT).
I then insert a blank take and reverse the processes using dd but the input file references the correctly sequenced file (i.e.: ip=./file#).
When I've dd'ed all the files the tape is ready.
I've duplicated mksysb tapes and sent them to remote sites and was successful in having them reboot.
Long, tedius, there must be a better way, but IT WORKS!
Good luck.
Bob
As root, I created a temp directory and cd'ed into it.
I dd'd from device /dev/rmt?.1 to a file with a sequence number (i.e.: of=./file#) which reads until end of file but does not rewind.
I do this continually until a read error (at EOT).
I then insert a blank take and reverse the processes using dd but the input file references the correctly sequenced file (i.e.: ip=./file#).
When I've dd'ed all the files the tape is ready.
I've duplicated mksysb tapes and sent them to remote sites and was successful in having them reboot.
Long, tedius, there must be a better way, but IT WORKS!
Good luck.
Bob
- Status