Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to do a checkup in a CME?

Status
Not open for further replies.
JuanCarman

JuanCarman

IS-IT--Management
May 30, 2016
73
MX
We want to generate a procedure to check the status of a CME, like trunk groups, alarms, events, errors, ds1s, etc.

All that we could need to check to confirm that everything is working fine.

Is there a document or a list of commands that we should run in the CME?

 
Sort by date Sort by votes
Hello folks,

I have not been able to find any information about this.
Any idea?

Thank you very much in advance!!
Regards
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

mikedphones
  • Locked
  • Question
MASS - Looking for a Cisco Call Manager support tech to move and reconfigure
Replies
0
Views
415
mikedphones
mikedphones
Gnjiro
  • Locked
  • Question
Cisco Ip Phone 7841, 7821 Delay when making call both inbound and outbound in sip protocol
Replies
3
Views
456
thepfy
thepfy
keyset6
  • Locked
  • Question
Access line in use from Jabber
Replies
2
Views
287
keyset6
keyset6
Russell35674
  • Locked
  • Question
Cisco VG310/320 migrate from SCCP to MGCP
Replies
1
Views
425
whykap
whykap
R_Inzano
  • Locked
  • Question
Callmanager waiting to pick up a call
Replies
2
Views
177
whykap
whykap

Part and Inventory Search

Sponsor

Back
Top