mikehiland
MIS
I have configured policies to process a backup template followed by a duplicate template. The daily differentials run just fine. This past weekend, the full backup completed but the duplicate failed with the error:
e0009444 - The requested source duplicate backup sets catalog record could not be found. Perhaps the media containing the source backup sets was previously deleted.
For additional information regarding this error refer to link V-79-57344-37956
So, the backup job runs and completes; then about 2 minutes later the duplicate job fails because it cannot find the media. I am notified and can manually run a duplicate job of the "missing" media without any problem. The media is there - why can't the duplication job see that?
I suspect that the catalog has not been fully updated before the duplicate tries to run. Is there a way to delay the duplication job? I do not want to schedule it to run at a specific time in case the backup takes longer than expected. I would rather it start shortly after the backup completes.
Thanks for any thoughts or suggestions!
e0009444 - The requested source duplicate backup sets catalog record could not be found. Perhaps the media containing the source backup sets was previously deleted.
For additional information regarding this error refer to link V-79-57344-37956
So, the backup job runs and completes; then about 2 minutes later the duplicate job fails because it cannot find the media. I am notified and can manually run a duplicate job of the "missing" media without any problem. The media is there - why can't the duplication job see that?
I suspect that the catalog has not been fully updated before the duplicate tries to run. Is there a way to delay the duplication job? I do not want to schedule it to run at a specific time in case the backup takes longer than expected. I would rather it start shortly after the backup completes.
Thanks for any thoughts or suggestions!