How to connect Cisco router 3725 to MD110 using E1 CAS (DTMF)

[rokane]

Has anyone have experienced on how to connect E1 CAS (DTMF)
interface to Cisco router 3725? Pls post the MD110 parameters here, thanks.

 

[rokane]

the board is TLU76/3.

 

[singhbrindisi]

Try This, it works fine with cisco 3810:
<RODAP:ROU=**;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
** TL37 H'00000000 H'00000046 H'0004160E NO

END

<ROCAP:ROU=**;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
** 011000000000001 5 3110000001 0 5 50 00060612 111110000000 001100
BR

 

[rokane]

singhbrindisi,

thanks for your response,I will try this & let you know if it works. The MD110 is running on BC8 software.



rokane

 

[rokane]

hello singhbrindisi,

it works alright but only for outgoing calls,incoming calls
not registered to called party although susip test on the route indicates particular channel seized.

rokane

 

[megglesfield]

I know you wanted CAS to the MD and your hardware supports CAS but it is however possible to run Qsig at the MD110 end, and CAS, FXS or whatever at the router at the other destinations. This method provides CLI which can be useful.

 

[bram123]

MD110 TL76/3 CAS interworking with Cisco 1760V.

Can anyone assist with both MD "RODAP, ROCAP, & NUTRP" Config. Plus Anything special for the Router end.

I want to make the PBX Network(Master) and Router User(Slave)