how to configure watch guard

[MIS789]

Dear all,

Iam a new user to configure watch guard. I need some help from all of u to configure my watch guard . I have experience in checkpoint firewall but not in watch guard firewall

My watchguard setup three network

External :- This NIC also have Public IP This network connected to router
Optional :- This network have public IP and connected to DNS server public IP there is no NAT for DNS
Trusted :- This NIC connected to our backbone and exchange 5.5 mails erver also in backbone
exchange mail server private IP was NAT with public IP in Advance NAT Setting
Enable 1 – TO – 1 NAT.

I enable outlook web access in exchange server it’s was working fine from internal back bone systems.
I need to access our exchange server from out side through

http://mailserver.shiva.com.sg/exchange

What & how do I need to configure in watch guard please help me . I am trying from fast 15 days but iam unable.

Thanks & Regards
Shiva Shankar .S

 

[joeinova]

Have you enabled http from authenticated user to ip address of Exchange Server? Next make sure that you authenticate to the firewall, minimize the applett and then type in the ip address of your exchange server.

 

[Ntr0P]

If you just want to allow http port 80 traffic to your server, enable an inbound service to the server. If you are using 1:1 nat you can do this as follows:

Inbound:
From: Any
To: 1:1 public ip of server