How to configure MPxIO multiple LUNs under Solaris10u3 1

[aidanhayes99]

MPxIO on Solaris 10 U3 x86 is successfull under default scsi_vhci for single LUN, but not for multipe LUNs, though seen under Show SCSI LUN command:

# cfgadm -al -o show_SCSI_LUN c2
Ap_Id Type Receptacle Occupant Condition
c2 fc-private connected configured unknown
c2::200100172a3100c2,0 disk connected configured unknown
c2::200100172a3100c2,1 disk connected configured unknown
c2::200100172a3100c2,2 disk connected configured unknown
c2::200100172a3100c2,3 disk connected configured unknown
c2::200100172a3100c2,4 disk connected configured unknown
c2::200100172a3100c2,5 disk connected configured unknown
c2::200100172a3100c2,6 disk connected configured unknown
c2::200100172a3100c2,7 disk connected configured unknown
# cfgadm -al -o show_SCSI_LUN c3
Ap_Id Type Receptacle Occupant Condition
c3 fc-private connected configured unknown
c3::200300172a3100c2,0 disk connected configured unknown
c3::200300172a3100c2,1 disk connected configured unknown
c3::200300172a3100c2,2 disk connected configured unknown
c3::200300172a3100c2,3 disk connected configured unknown
c3::200300172a3100c2,4 disk connected configured unknown
c3::200300172a3100c2,5 disk connected configured unknown
c3::200300172a3100c2,6 disk connected configured unknown
c3::200300172a3100c2,7 disk connected configured unknown
#

 

[aidanhayes99]

Resolved by array firmware update with improved Inquiry Page 83h for multipathing