How to change logging level?

[cmtoth]

Ok, this is a stupid question, but I've looked on this forum and Googled it.

Once you have logging enabled to log to a syslog daemon, how do you change the logging level?

I currently have it on 6(informational), but I want to change it to 5(notification)

I have tried:

logging trap 5
logging trap notification
logging facility 5

But I always get the response: Usage: clear logging

I tried typing in clear logging, but that doesn't do anything either.

Could anyone give me a clue?

Thanks

 

[Minue]

Hello
The logging on the PIX is quite straight-forward.These are the command neeeded.
PIX1(config)# logging host inside 192.168.50.8
PIX1(config)# logging trap notification
PIX1(config)# logging on

This should work!Just try turning off logging and then issue the above commands.Do a "show logging" to verify.If it doesn't work check to see if your syslog server needs configuring as well.
Regards

 

[Supergrrover]

Was the syslog server working already?
(check the personal firewall)

What syslog server are you using? What port/protocol is it using?

For the UDP port, the default is 514 and for the TCP port, the default is 1470.



Brent
Systems Engineer / Consultant
CCNP, CCSP