How to build a PRI from scratch.

[pbxadmin2]

Ok I just need to know what overlays to goto, what to input and how do I setup the MSDL to work.

I am building a PRI going into a 81C, using a Dual PRI card and a MSDL card for the DCH.

 

[Avaya911PLM]

If you look at the Nortel NTP's for 1.5Mb PRI/DTI installation, they will walk you through it step by step, load by load.

--
Fletch
Visit the Nortel Technical Support Portal at:

http://www.nortelnetworks.com/support

 

[fred8677]

pbxadmin2,
Did you find what you are looking for? I've been searching the forum because I don't have the installation NTPs.

I'm converting 2 straight T1s to PRI in order to get caller ID. I've set up trunk groups before but no clue how to set up PRIs.

If I find something helpful, I'll post it here.

"Wise men learn more from fools than fools from wise men

 

[johnpoole]

ld 17
EQ chg
TYPE cequ
MPED
TERM
REMO
TERD
REMD
TERQ
REMQ
XCT
TDS
CONF
MFSD
DLOP (loop number) 23 esf
you've got a new pri

ld 17 chg
adan
adan= new dch x
you'll need the device number (switch setting)
and the port number.. + card type..
CTYP MSDL
GRP 2
DNUM 14
PORT 2
DES ARDENCO
USR PRI
DCHL 109
OTBF 32
PARM RS422 DTE
DRAT 64KC
CLOK EXT
IFC NI2
ISDN_MCNT 300
CLID OPT0
CO_TYPE ATT
SIDE USR
CNEG 1
RLS ID 1
RCAP COLP
T310 120
T200 3
T203 10
N200 3
N201 260
K 7
BSERV NO



that dch is very close to right if your interface is a att switch.. that may be ni2 etc..

then ld 21 prt net... check to see if net =yes

when you add your route, this one works for this switch type

ISDN YES
MODE PRA
IFC D250
SBN NO
PNI 00000
NCNA YES
NCRD NO
CHTY BCH
CTYP UKWN
INAC NO
ISAR NO
CPUB OFF
DAPC NO
BCOT 0
DSEL VCE


that is a ld route.. ie the dms 250 interface..yours may change


john poole
bellsouth business
columbia,sc