I have tried to add multiple LDID codes in LD90 to go to different DMI tables I built in LD86, but when you do a printout in LD90, it shows all the codes in the same DMI even though it was programmed into different ones. I need them to go to different DMI's as they are sent into the application builder for DOW & TOD routing to different numbers. Any insight would be great.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to add multilpe LDID codes same NPA to different destinations
- Thread starter bdean002
- Start date
You may need to do a 2-stage conversion.
When you define the DMI for the LDID, add some unique digits to the front of the number and change the call type to CDP.
In CDP build different entries based on the unique digits plus any additional digits needed to differentiate the numbers you want to deal with. Send these to separate RLI's with LTER set to yes, and create another DMI to change the number to whatever you will be using in application builder.
When you define the DMI for the LDID, add some unique digits to the front of the number and change the call type to CDP.
In CDP build different entries based on the unique digits plus any additional digits needed to differentiate the numbers you want to deal with. Send these to separate RLI's with LTER set to yes, and create another DMI to change the number to whatever you will be using in application builder.
- Status
Similar threads
- Locked
- Question
