how the create Hotline system at Hi 1

[Tosu]

how the create Hotline system at Hicom300E V3..

i have put on the feasu and in the cos a fitur hot and ahot but not working. anybody know

 

[hipath4k]

Dear TOSU

In hicom version it i will configure through ITR and ZIEL

 

[sbcsu]

Add Hot or Hotln to COS of phone
Add HOT to SDAT
Define destinations in ADD-HOT or ADD-HOTLN ?

 

[Moriendi]

Is this really EV3.0 software ? Old.

The hotline feature automatically sets up voice, TTX, VTX and DTE connections immediately after initial seizure. The destinations must be assigned to the ITR group of the station.

Assign a hotline destination for VOICE
AD-VBZGR:GROUP=number,TYPE=HOTDEST,HOTVCE=key-num;
Activate the feature:
CHA-FEASU:A,HOTRCL;
The station must have the COS in the COSSU:
CHA-COSSU:TYPE=COS,COS=<number>,AVCE=AHOT;
The off-hook recall feature automatically sets up a connection to a preset destination assigned to the ITR group of this station, if either no digits are dialled, or only an incomplete digit sequence is dialled within a preset time after initial seizure. This feature is provided for the VOICE service only. The parameter GROUP in the AMO VBZGR defines the internal traffic restriction group of the station.
Assign an off-hook recall destination
AD-VBZGR:GROUP=number,TYPE=OFRCDEST,OFFRCL=key-num;
Activate the feature:
CHA-FEASU:A,HOTRCL;
The station must have the COS in the COSSU:
CHA-COSSU:TYPE=COS,COS=<number>,AVCE=AHOT;
Change the time for automatic connection setup in AMO DTIM2:
CHA-DTIM2:TYPEDH=GEN,DTNT1=10; 10 seconds is default value.

 

[donb01]

He says Hicom 300E. My brain says 9751 - 9006 hardware, so that would be 9006.3 if that is what he means. In that case the AMOs are a little difference. You have to create the HOTDEST (ITRHO) for off hook and then you assign that HOTDEST number to the station in SCSU. The station needs to have a COS that includes the HOT attributes. I would have to look in the book to get the exact commands, but I believe that ADD-ITRHO will let you add the hotdest, CHA-SCSU will allow you to assign it, and then you need to have a COS for that. You could start with DIS-COS to see if there is already one set up I think. I *think* the COS parameter is HOT.

Don Bruechert, Voice Comm Analyst II
CareTech Solutions @ Holy Family Memorial
Manitowoc, WI, USA

 

[keyset6]

I was also going to say - I think he's looking for 9006 commands. There are still a few 9006.3 systems out there.

 

[Tosu]

ok- right, thank a lot of you all

i will try

 

[hipath4k]

Dear Tosu

Please let me know if you are facing problem..

 

[Tosu]

hotline already run , great of all