HOW SETUP DTI'S

[jftg73]

HI

I NEED SETUP A LINK WITH OURS PBX 61C BUT I NEED INSTALL TWO DTI'S, BUT I DON´T HAVE IDEA WHAT TO CREATE FIRST, IF TRUNK IN LD 14 THEN RLB EN LD 16 AND WHAT PARAMETERS, ANYBODY CAN U ASSIST ME? BECAUSE I DON'T HAVE EXPERIENCE IN THIS BUT IF YOU TELL ME HOW I DO IT.

THANKS.

 

[steyler]

You will need to setup the route and then add the individual members to it. LD 16 for the new route, LD 14 to add the loop/route members.

 

[1brc]

You also have to change the CEQU in ld 17

 

[jftg73]

THANKS STEILER AND 1BRC, I HAS PROGRAMMED MY ROUTE AND DTI HOW TIE, BUT HOW I CAN CHECK THAT MY LINK IS GOOD, I TRY WITH ACOD+NUMBER EXT. BUT I CAN GET CONNECTION, I NEED ANOTHER THING THAT PROGRAMMER IN MY SYSTEM?

THANKS.

 

[rtycka]

The following is a summary of the tasks in this section:
1 LD 17 – Add a 2.0 Mb DTI card.
2 LD 73 – Define the 2.0 Mb DTI ABCD signaling bit tables.
3 LD 73 – Define the 2.0 Mb DTI pad tables.
4 LD 73 – Define the 2.0 Mb DTI timers.
5 LD 73 – Define the 2.0 Mb DTI system timers.
6 LD 16 – Configure the service routes.
7 LD 14 – Define the associated list of service trunks.

 

[rtycka]

NTP 553-3011-315