I will be removing DID Trunks from my switch and pointing my main number to an existing T-1 that we just had installed a few months ago. Is there anything I need to check to make sure when this main number is pointed to the new circuit that the operatore console will still recieve calls? Or is it as simple as just pointing the DID to the new circuit?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How lines ring to an Operator Console
- Thread starter lynmar
- Start date
Hello Lynmar,
Is this main number currently on a copper line now that autoterminates to the console? When you point the number to your T1, are you going to have it carry a DNIS/DID value? If so, do you have that value defined in your PBX as a LDN that is a key on your console? Print a DNB on the DID/DNIS you have the main number carry into the PBX.
Is this main number currently on a copper line now that autoterminates to the console? When you point the number to your T1, are you going to have it carry a DNIS/DID value? If so, do you have that value defined in your PBX as a LDN that is a key on your console? Print a DNB on the DID/DNIS you have the main number carry into the PBX.
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question