Alright I have about pulled out what little hair I have left working on the INA board, I have used the passthru option on the win spm to setup the "ether0" ip address, the only problem is when you get into the PM vision software to finish programming or restore a configuration the ip address is assign to the "INA" and not the "Portmaster" like it is on the old bad card, in general it does not communicate with the other merlin magix acros the t-1, I have worked and read on this for the past several days and I am at a loss, I know someone has run into this before, any tips would be great
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
how do you program the IP address on the portmaster setting in a INA??
- Thread starter IPOguy
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question