Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How do you configure 2 NICs for NT?
- Thread starter grimland
- Start date
TheOtherKiwi
MIS
It is my understanding that the Raptor set up process configures the network cards depending on which card you designate as "outside" (internet connected) and "inside" (lan connected).
You should not need to reconfigure the cards after assigning them an IP address and plugging them in to the approporiate location after Raptor is installed.
Try a reinstall and check to see that you at least have physical connectivity on the LAN side before installing Raptor.
You should not need to reconfigure the cards after assigning them an IP address and plugging them in to the approporiate location after Raptor is installed.
Try a reinstall and check to see that you at least have physical connectivity on the LAN side before installing Raptor.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question