How do I wire a Bogen T725 to a BCM?

[Devon357]

I ma used to wiring Tip, Ring, Ground and 24V on a Valcom but this Bogen has me stumpped.


Devon357

 

[biv343]

The page port on the MSC card will give you a 600 ohm output - that might work if you have a line level input on the Bogen. Otherwise, you can go off a station port or trunk port to the unit. I've used a (think it's made by Bogen) TAM-B interface device to go between an ATA and the page amp - the TAM-B answers the call to the analog port and passes the output through to the input of the amp.

If your amp has trunk level, just hook up a spare analog trunk port to the bogen unit, and assign that trunk port it's own access code.

 

[Devon357]

I plan on using a Bogen Amp, It is just wierd to me all the wires hanging of the speakers, when normally I would use tip ring pwr and ground

Thanks for your reply