Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

How do I setup DHCP on a Netbuilder 227 router?

Status
Not open for further replies.
networkman12480

networkman12480

MIS
Dec 19, 2007
2
US
In our network we have a frame relay LAN, using two Netbuilder 227C routers. The head end router runs 9.1 code, the far end runs 9.3 code. They are both SW/NBRO-CF routers as well. How do we go about enabling and getting DHCP to run on them? What commands do I use? I tried using the AuthDHCPServ command, and even enabling it at both ends did not do anything. Is there more than just that to getting DHCP to work? Any help would be great! Thanks.
 
Status
Not open for further replies.

Similar threads

CHRISH KYLE
  • Locked
  • Question
how to reset netgear router password in hp laptop......
Replies
0
Views
115
CHRISH KYLE
CHRISH KYLE
kryptor
  • Locked
  • Question
VLANs causing me a headache!!
Replies
1
Views
264
meneerB
meneerB
starmanjl
  • Locked
  • Question
Can someone direct me to some docum
Replies
1
Views
133
meneerB
meneerB
davea2
  • Locked
  • Question
Distribute public IP addresses
Replies
0
Views
114
davea2
davea2
Wadoki
  • Locked
  • Question
What is the command to enable 3rd party SFP+ transceivers on HP switch?
Replies
0
Views
137
Wadoki
Wadoki

Part and Inventory Search

Sponsor

Back
Top