Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How do I set a IP address to a 2501 Cisco's Router?
- Thread starter kaosk
- Start date
Is there a question here?
Where do you want to to set the IP address?
If it is on a workstation of some sort,there setup a static route to the Router using the route add command, e.g. if you are on network 192.168.1.0 and want to route to machines on network 192.168.2.0 through a router with ip address 0f 192.168.1.254 then you can set up a static route on your workstations with the command like
route add net 192.168.2.0 192.168.1.254
Richard
richard@brecon.co.uk
Where do you want to to set the IP address?
If it is on a workstation of some sort,there setup a static route to the Router using the route add command, e.g. if you are on network 192.168.1.0 and want to route to machines on network 192.168.2.0 through a router with ip address 0f 192.168.1.254 then you can set up a static route on your workstations with the command like
route add net 192.168.2.0 192.168.1.254
Richard
richard@brecon.co.uk
Get to enable mode than type in the commands:
config t (enter)
than type in the interface you want the address on and the ip address.
interface e0
ip address 192.168.56.1 255.255.255.0
no shut
You need to do this for each interface you are going to use.
each needs its own address.
config t (enter)
than type in the interface you want the address on and the ip address.
interface e0
ip address 192.168.56.1 255.255.255.0
no shut
You need to do this for each interface you are going to use.
each needs its own address.
- Status
Similar threads
- Locked
- Helpful tip
- Locked
- Question