how do i program a T1

[dontel80]

i need to know the steps in programming a t1 on guestworks. i had done One T1 about 2 years ago. i cannot remember all the steps. i just need to all related programming steps.

 

[bhanson184]

I have not work with guestworks but am assuming it programs the same as any other Definity.

1. add ds1 XXXX (carrier and slot)
DS1 CIRCUIT PACK

Location: 01B20 Name: LOCAL 4
Bit Rate: 1.544 Line Coding: b8zs
Line Compensation: 1 Framing Mode: esf
Signaling Mode: robbed-bit

Interface Companding: mulaw
Idle Code: 11111111


Slip Detection? y Near-end CSU Type: integrated

Echo Cancellation? n

This is for a standred T1 not PRI/ISDN

Add or change your trunk group to tie.

TRUNK GROUP

Group Number: 10 Group Type: tie CDR Reports: y
Group Name: LONG DIST ATT COR: 61 TN: 1 TAC: 710
Direction:two-way Outgoing Display? y Trunk Signaling Type:
Dial Access? n Busy Threshold: 99 Night Service:
Queue Length: 0 Incoming Destination:
Comm Type: voice Auth Code? n
Trunk Flash? n

TRUNK PARAMETERS
Trunk Type (in/out): wink/wink Incoming Rotary Timeout(sec): 5
Outgoing Dial Type: tone Incoming Dial Type: tone
Wink Timer(msec): 5000 Disconnect Timing(msec): 500
DigitTreatment: Digits:
Sig Bit Inversion: none
Analog Loss Group: 9 Digital Loss Group: 13
Incoming Dial Tone? y

Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 10 Receive Answer Supervision? n