Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

How do I make a funnel?

Status
Not open for further replies.

dicktracy28

Vendor
Jan 30, 2007
1
CA
Hi, I have can with a radius of 1.6605 inches. I would like to make two concentric arcs that I can then print out, cut out and tape to make a funnel to fit on the end of this tin can. I would like the inner radius of the funnel to be 1.6605 inches and the outer radius to be 4 inches. In fireworks I’ve used the doughnut tool to make an inner circle with a 1.6605 inch radius and an outer circle with a 4 inch radius. I’m not sure what else I need to do to make a funnel. Thank you.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top