finestdecals
Vendor
I would like to be able to take a pattern an trim say like 1/8" around the perameter so that i can have an outline. i know i can just outline the original pattern but i would liket o do the reverse. thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How do I make a duplicate pattern that is smaller but not scewed.
- Thread starter finestdecals
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question