How do I get call log information (SMDR) to work 3

[richtech]

I need station message detail recording information for a 3rd party platform to develope a call record database. What format does norstar 8X24 running DR5 develope and how do you get an output?

 

[bkrike]

Try searching...
thread799-652973
thread799-846498
thread799-614095

 

[richtech]

Good threads, but being a 8X24, I can't have a T1, but is there a way to get caller ID to work on the first 8 trunks? CI modules could be put installed in the 12X0's to cover all other trunks.

 

[jerryreeve]

Since you are using an 8X24 check out
faq799-3925
this is an add on unit that goes ahead of the 8X24


If voting could really change things, it would be illegal.

JerryReeve
Communications Systems Int'l
com-sys.com

 

[richtech]

So I can get caller ID on the first 8 trunks only? The TCM connectors, are they used to bring station information to the SMDR unit? I need 8 pairs for trunks and 8 pairs for stations?

 

[jerryreeve]

the CII uses one station port to stream the data into the norstar and it can be used for up to 8 co ports on the main unit only not the tm.

If voting could really change things, it would be illegal.

JerryReeve
Communications Systems Int'l
com-sys.com

 

[richtech]

I have 16 trunks in the system. If I have caller ID trunk cartridges in the TM's, will I get SMDR for all the trunks and stations?

 

[jerryreeve]

I do not think so, the CII was for the 8 lines on the main unit of the norstar, the Trunk Module was not mentioned.

Melissa, Exmogger, Curly? any comments?

If voting could really change things, it would be illegal.

JerryReeve
Communications Systems Int'l
com-sys.com