How do I determine DNUM on Option 71XT?

[mermale]

I am adding a DDP card with daughtherboard to a Meridian Option 71 XT. This will be a tie a Lucent switch we have in another building.

My Meridian knowledge is a bit rusty. I programmed the route and added the 2 loops on this card to the Common Equipment database. Since the DDP card replaced a network card, I knew what loops they were going to be.
Now I need to set the device number on the DDP card, and program the D-Channels. This is where I'm getting stuck. I printed out the D-Channels on other DDP cards in the same network group, but I cannot figure out how those numbers correspond with the actual slot numbers that they occupy.

Merle.

 

[freddog]

Print out all your ADANs in LD 22. This will show you what DNUMs have already been assigned. Just pick a number that has not been used as your new DNUM and set your card accordingly.

LD 22
REQ PRT
TYPE ADAN <Enter>