HiPath 500 and BS4 connection

[aleksandia]

Hi everyone,

I have a HiPath 500 V9 that I'd like to use with the BS4 base station. I have the CMS-Card connected and have connected the BS4 according to the instructions. However when turning on the unit the BS4 unit only lights up the red LED solid and only briefly both the red and green LED light up. Afterwards the green LED only lights up briefly and shuts of immeadiately until the unit resets and the procedure repeats.
I don't know what the problem may be as I have followed the service documentation and managed to verify that the hardware is compatible.
When going into the maintenance-window and checking the status of the base station I sometimes see something. I have attached a picture of the status.

Perhaps someone has some ideas.

Thank you in advance

 

[masviss]

It seems to me that you need to replace CMS with CMA.
This is a recommendation from the documentation.
And show us the pictures
Settings - Cordless - System-wide and so on.

 

[Lexzie]

A HiPath 500 cannot be equiped with a CMA.
Is the configuration done right?
How many basestations have you connected to the Up0/E-interfaces?
What lines are connected to the system?
Is it possible to share the kds?