Hipath 4000 v6 incoming call

[RonnieDio1]

Hi,
In Hipath 4000 V6R2 analog trunks no ring in extensions scheduled, in in version 6R1 worked well. In V6R2 Overflows for AC-Win Attendant IP.

 

[sbcsu]

In TACSU check DGTPR
DGTPR=Extension number of destination.

In COT/COP put DITW

 

[RonnieDio1]

Yes it is programmed this way. With DITW does not ring, without going to standard AC-Win IP.

 

[adibv]

I assume that it is about DIT feature (dedicated inward trunking) - Direct Inward Termination.
Some things to check:

The DITW feature (COP parameter DITW ) with digit prefixing (DGTPR in AMO TACSU) has the same effect in the case of a tie trunk.
Both features may not be used together.
•The feature is only effective in the case of incoming seizure type ATND or HAUS1.
•The COT parameter DIT must be set in the associated trunk.
•The COP parameters DITW, DTN, DTV may not be set when using the DIT feature.
•The COP parameters DTN (incoming seizure dial tone) and DTV (dial tone analysis) have no effect if the DIT feature is activated.
•The HOTRCL feature in AMO FEASU must be set, and a valid DITIDX configured in AMO TACSU and a subscriber number configured in AMO HOTLN.
•In AMO TACSU, the DITIDX must be in the range of 1 to 512; a DITIDX value of 0 acts as if no DIT feature had been configured.
•If no HOTLN number has been entered or if FEASU HOTRCL has not been set or the DITIDX in AMO TACSU has not been entered, the DIT feature is not executed. In this case, the call behaves as if no DIT feature has been configured (i.e. switching system call).

If the assigned DIT station is out of service or if the assigned station number is vacant, the incoming DIT call be routed to the attendant or to the night answer arrangement if no attendant is in service.
If the assigned station is not authorized to receive the call due to ITR group restriction, the incoming DIT call be routed to the attendant or to the night answer arrangement if no attendant is in service.

In ZAND: ALLDATA - check param:
TRDGTPR - Toll restriction for trunk calls with digit prefixing

 

[Moriendi]

Are you saying (a) this worked on V6 R1, you made an upgrade to R2, and now it doesn't work? Or are you saying (b) this works somewhere else on R1, and doesn't work here on R2?

If (a) then it might be worth checking what's changed - the loadware for the analogue trunks (TMANI? TM2LP?), if you saved the old image from the HD you could extract the older loadware and try that. If it was working on R1 I would think your config was already correct.

If (b) then yes, maybe config problem.

Is it not working to a VFGR group, is that what you're saying? Do you have the right CPS in VFGKZ? What happens if you change the DGTPR in TACSU to a normal extension, does that ring?

Does it go BUSY in SDSU when you try to dial in? Can you dial out? Is there any HISTA with an incoming call.