Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

HiPath 3500 unable to boot 1

Status
Not open for further replies.

aleksandia

Technical User
Feb 1, 2022
5
DE
Hi everyone,

I have a HiPath 3500 with the following part-number: S30810-Q2935-Z000-03. I got it without the MMC-card. Based of the part number I know the maximum firmware this board can run is V4. So I took a MMC-card that's 128 MB in size and flashed the correct firmware onto it. However whenever I start it up it only flashes which indicated that the contents on the MMC-card are incorrect or that the card is missing. I checked the release info and could not find any incompatibility.
I do not what's wrong as I made sure to use the right firmware and a MMC-card that was used in Siemens HiPath-systems.
Possibly I was flashing the MMC-card incorrectly.

I would appreciate some help as I seem to be unable to get this unit to boot up.

Thanks in advance,
Kind regards,
aleksandia
 
For the S30810-Q2935-Z000 processor, you need to use a MMC-card 16 mb.
MMC-card 32 mb will probably work.
 
So if my MMC-card is too large it's not going to work?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top