Hipath 3000 with HG1500 interconnecting problem with Unify V2x8 system.

[Harikt]

Hi All
I have three different Hipath 3000 series with hg1500 V7 interconnecting with H323 in different locations. Networking is working with LCR and without LCR are working fine. Now we installed a new unify V2x8 system with network license on new location and we are unable to interconnecting with the existing system. The new unify V2x8 has only SIPQ protocol. There is SIPQ protocol in hipath 3000 with HG1500 V7 system.
Please help me how to make it possible to interconnecting the New unify V2x8 with the old systems.

Thanking you

Hari

 

[yayayoyo]

Networking licence is for activate networking only between OSB systems but to connect OSB with H3K you need this licence "OpenScape Business S2M/SIP Trunks" . good luck !!!

 

[Harikt]

Thanks for the suggestion and i have activated 4 ports S2M/SIP Trunks
OpenScape Business V2 OpenScape Business S2M/SIP Trunks 0 of 4 valid

http://www.tek-tips.com/viewthread.cfm?qid=1774428

Please suggest the configuration template for both.
Thanking you.

 

[ramn20]

I have a working solution to problem.
first on the Hipath 3000-HG1500 v8 create a node and assign the ip address and then edit the IP protocol to SIP-Q. create the routes
Second on your manager e create Ext.sip Trunks
third on your manage e enter the ext sip ip address
assign your LCR for that node and upload your configuration.

On openscape business create networking trunks
create a node on the system assign the ip address
assign your LCR
Create the routes
You should have the two system communicationg

the Hipath with ext sip becomes the gateway for the others.

 

[yiorgosp]

Hello ramn20 I try this solution without any luck. In Osbiz we need also a networking licence?

 

[ramn20]

Yes you need networking licence
I have done a second installation.
The idea is to have open business work as an ope sip device.
I have screen shots of the configs attached.
Also i have attached kds
i hope this will assist

 

[imtiazbajwa]

Only networking license required in OSB (which you have)
add trunks to networking trunk group 16
you are create "Nodes" for Hipath 3000 in voice gateway (Expert mode)
activate LCR all the routings to Hipath system via trunk group 16 "networking"

In Hipath 3000 V7 to V9 add new nodes for OSB with "SIPQ" protocole.
rest all the configurations as hipath 3000.

Br, Imtiaz