Higher IPS not routing?!

[CMASPE]

I have a PIX 515 with CIOS 5.2. and I don't even know if this is a PIX problem. I have my CCNA but no experience with PIX so I am fumbling through it. I have a 24 bit masked IP range and my unused IP's over .15 are not able to get out to the "real" world. I have looked for an access-list on both the router and PIX and can not find a reason for this issue. I just "took" over this network so I was not involved in the setup. Any help appreciated.
CA

 

[yizhar]

HI!

You must read PIX documentation to understand and maintain it. CCNA isn't enough as you figurred.

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix

If you post here the PIX configuration and network design, we can help you better.

Bye

Yizhar Hurwitz

http://come.to/yizhar

http://teachers.sivan.co.il/yizhar

 

[CMASPE]

actually after digging through the sites I discovered the static command and low and behold every IP that could get out was on there. So I entered my Static command and IP and boom I am getting out. You are correct that CCNA is not enough to maintain but it is enough to feel comfortable poking around in the PIX. Thanks