hicom300 AMO s

[telecomengr]

Hi everybody,

Can anybody provide AMO for configuring Incomming call, COS, Trunk group, to know system details, like SW vesion NO. OF cabinets, and type of cards installed ( Like in Hipath 3000 we can see this information system wide information)

Thanks in advance

with best regards
Joshy

 

[donb01]

You can see how many shelves there are and the cards that are configured for each, whether they are there, etc by using this command:

DIS-BCSU:TBL,;

The first cabinet can have up to 4 telephony shelves, so if you have more than 4 there is a second cabinet, if you have more than 10 there is likely a third.

You can use this command to see how many open ports you have, where they are and what type they are. Any port that says NOGEN for its status is open. Any board that says NOGEN for its status is not installed.

DIS-SDSU:NOGEN,,PEN,PER2;

You can look at your trunk groups with:

DIS-TGACC;

You can look at individual trunks with:

DIS-TCSU and providing a PEN or PENs.

You can look at COS with:

DIS-COS (I believe you can use ALLCOS for type= )

These commands assume you are using Direct AMO. If you are using the EMML shell you will have to use <shift><F5> to get a command box, then enter the command without the dash in between, and fill in the options in the boxes provided.

Hope this helps a bit.