Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Hi all: MD110 VER. BC11 locking e
- Thread starter jazaya
- Start date
- Thread starter
- #3
Why do adn's have a cat that allows dialing out anyway
isn't enough that they dial out on the odn .
I always use restricted cat for adn's but leave them open for DID calls.
Iv'e not managed to figure out this in the manuals .
Possible that only solution is to assign auth codes
for the adn's also ,resulting in pressing each adn and key in the lock down code.
//Soaplover
isn't enough that they dial out on the odn .
I always use restricted cat for adn's but leave them open for DID calls.
Iv'e not managed to figure out this in the manuals .
Possible that only solution is to assign auth codes
for the adn's also ,resulting in pressing each adn and key in the lock down code.
//Soaplover
- Thread starter
- #5
Thanks Soaplover:
I use the ADNs for dedicated Co.Lines.Hotline them to their Dest and there they go.
I beleive there was a patch to do this (Locking ADNs and ODN at the same time) in previous versions.
But thanks for replying anyway
Regards
Experience it, there is no substitute.
RemoveThisJazayeri@kiasagroup.com
I use the ADNs for dedicated Co.Lines.Hotline them to their Dest and there they go.
I beleive there was a patch to do this (Locking ADNs and ODN at the same time) in previous versions.
But thanks for replying anyway
Regards
Experience it, there is no substitute.
RemoveThisJazayeri@kiasagroup.com
- Thread starter
- #6
Ok.You see the scenario is as follows:
An Adn is hotlined to a dest.I tried changing it to the delayed hotline option and locked it with authority code.However it seems that the holtline feature overrides any locking! and it still dials the the dest and enables the user to make external calls.Situation is the same in BC9.
AAny suggestions?
Regards
Experience it, there is no substitute.
RemoveThisJazayeri@kiasagroup.com
An Adn is hotlined to a dest.I tried changing it to the delayed hotline option and locked it with authority code.However it seems that the holtline feature overrides any locking! and it still dials the the dest and enables the user to make external calls.Situation is the same in BC9.
AAny suggestions?
Regards
Experience it, there is no substitute.
RemoveThisJazayeri@kiasagroup.com
- Status
