Help with wiring of 24DTA-A card on IVS2000?

[phadobas]

I'm working on setting up an old IVS2000. I'm using a 24DTA-A card for T1 trunking. Where do I punch down the T1 on the punchdown block to connect it to this T1 card? I put the card in the LT10/AP0 slot. That slot is on the 2nd 25-pair cable that connects to the system. There is a total of 3 25-pair cables. I have 4-port analog and digital line cards in slots LT0-LT6, and they pretty much punch down in sequence on the punch-down block. But for the life of me, I couldn't find anywhere in the documentation how you cross-connect a T1 card. Checked the Command Manual, the Configuration Guide, the Install Manual, found T1 Cheat-sheets, but they are all for programming.

Anybody knows? Thanks

 

[gbaughma]

If I remember right, it would go on the topmost pair for that card.... So, it should be on the second block, pair 13 (Umm... black/green) (I think... it's been a long time).

I'm sure someone will correct me if I'm wrong.

Just my 2¢
-Cole's Law: Shredded cabbage

--Greg

http://parallel.tzo.com

 

[OzzieGeorge]

See the ISDN manual. Can be found here....

http://www.wedophones.com/NecManualsLead.htm

Try chapter 3 page 38 but remember the DTA is a new card but it connects in the same way as the old cards!

 

[LDthirtytwo]

LTC 01, pairs 17 & 18= YL O/O YL & YL GRN/GRN YL

 

[phadobas]

Thank you all.