We just installed SCREEN from the Linux Toolbox based on recommendations of someone in this forum ... the only problem is this utility only supports VT100 or ANSI emulation ... all of our settings for VI in .exrc (map blah) are setup for WYSE60 keys specifically the F'keys.
Two questions;
Assuming VT100 is used would it be better to try and modify the TERMCAP defaults to emulate the Wyse60 Keys or would it be better to add the VT100 key equivalents to the .exrc file?
Again Assuming VT100 is there anywhere on the web that I could find a generic cross over from Wyse60 to VT100?
Two questions;
Assuming VT100 is used would it be better to try and modify the TERMCAP defaults to emulate the Wyse60 Keys or would it be better to add the VT100 key equivalents to the .exrc file?
Again Assuming VT100 is there anywhere on the web that I could find a generic cross over from Wyse60 to VT100?