Help with PIX 506 and Cable Modem

[puma1824]

Presently I have a PIX 506 (v5.3) and a Cable Modem. My ISP only provides 1 IP address assigned via DHCP.

I have successfully been able to obtain the extenal interface IP address and routes. Unfortunately I have not been able to configure the PIX to correctly share internet with the Internal clients.

Not sure if I can even do it. From my understanding I need a Global entry that can't be the same as the external interface which gets assigned by DHCP.

If someone knows how I can do it it would be greatly appreciated.

Thanks,
Ron

 

[puma1824]

Furthermore I just updated to 6.1 and installed PDM.

Ran setup BUT I can't get to it from a browser.

HELP....yes I'm a newbie

::Ron

 

[yizhar]

HI.

>> Furthermore I just updated to 6.1 and installed PDM
Good.

>> Ran setup BUT I can't get to it from a browser.
You must use HTTPS - not HTTP. Read the small letters.

https://pixinsideinterface

>> Sharing the pix own interface address to clients is done with the command:
global 1 interface

But if you establish PDM connection so you can configure it from there.

Bye



Yizhar Hurwitz

http://come.to/yizhar

http://teachers.sivan.co.il/yizhar

 

[puma1824]

...so if I take out the NAT statements I just need to add global 1 interface??

::Ron

 

[yizhar]

HI.

You'll need both NAT and GLOBAL statements:

nat 1 0 0
global 1 interface

Bye
Yizhar Hurwitz

http://come.to/yizhar

http://teachers.sivan.co.il/yizhar

 

[puma1824]

yizhar thanks and do I need to make any global statements? Or do I just need global 1 interface??

Thanks,
Ron

 

[yizhar]

HI.

In your case, global 1 interface should be enough.

Bye
Yizhar Hurwitz

http://come.to/yizhar

http://teachers.sivan.co.il/yizhar