Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
help with multilink
- Thread starter smcguinn
- Start date
I tried yesterday to set up multilink over 2 X.21 links with the same bandwidth.
You just have to get rid of IPs, ACLs etc in the Serials and create a Multilink1 interface. You can config this interface with IPs and ACLs. The trick is that you have to conf the serial and the multilink, giving the commands:
multilink-group 1
ppp multilink
Also you have to check your routing (especially statics routes)
To be honest it did not work for me. I had packet loss for packets over 200 Bytes that i could not find out where the problem was. Someonte told me about ppp fragmentation...
You just have to get rid of IPs, ACLs etc in the Serials and create a Multilink1 interface. You can config this interface with IPs and ACLs. The trick is that you have to conf the serial and the multilink, giving the commands:
multilink-group 1
ppp multilink
Also you have to check your routing (especially statics routes)
To be honest it did not work for me. I had packet loss for packets over 200 Bytes that i could not find out where the problem was. Someonte told me about ppp fragmentation...
- Status
