Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

HELP with Microtest MT350 1

Status
Not open for further replies.

networkstudent

Technical User
Sep 12, 2002
23
VE
Hi everybody and thanks for looking,

I need the MT350 or MT310 (its the same cable as i know) printer cable pinout. and if there's any particular info about baud rate or any other serial parameter.

By the way, i does not have the manual, so if any of you knows if there{s a way to share data between a pc and the scanner, this help would be greatly appreciated.

Thanks a lot in advance, any help is very wellcome!!

bye
 
I have Fluke Onetouch tester. It is not Microtest, but I think pinouts should be same - it has DB9M port for connecting to a pc or a printer.
I have not used it with printer, but here is a pinout from the manual:

DB9F - DB25M
(dev) (prt)
2 - 2
3 - 3
4 - 6
5 - 7
6 - 20

However, I have used it to connect to a pc and upgrade the firmware. Here is a pinout from that cable:

DB9F - DB9F
1 -
2 - 3
3 - 2
4 - 6
5 -
6 - 4
7 -
8 -

Good luck.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top