Help with CallPilot 100 1

[phector]

Hi I'm a new tech working with nortel. I just obtained a used CallPilot 100. I was able to enter arp -a at the command prompt and get an ip of 192.168.110.255 but for some reason i just can't seem to ping it after setting my laptop to 192.168.110.254. I need to access the manager. can anyone help please?

 

[curlycord]

Use 9 pin and Hyper term, reboot CP and look for the correct IP of the CP.



=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[allworxguy]

192.168.110.255 is a network broadcast address. No host will have that address.

As Curly points out plug a serial cable in and reboot. You see the address.

Marv

http://www.telemarv.ca

 

[ptstechnician]

9600, 8-N-1.

 

[phector]

Thanks for the quick response. I'm going to try that.

 

[phector]

thanks again i was able to get through with your help.

 

[ringbacktone]

I have a CP100 that Bought back from a customer when they went VOIP. I read this post and tried to determine the IP address. I know it is default IP cause I can connect to it using IE.Tried using the 9 pin cable but nothing happened. Do I need a null adapter and or a cable with pins 2 and 3 reversed?

Thanks in advance,

RBT

 

[ironhorse17]

Did you power it down, will give you the info on start up, wait a few minutes.

 

[curlycord]

Null modem
8-N-1
9600

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[norstarboy125]

If you know the ip is still the default then did you try it?
192.168.110.10. What ip did you use when lauching IE?

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer