Help with Analog DID service

[jsaad]

I have a MICS 6.0 with an analog DID card in a trunk module. I want to test out the system before we install it. What I have done is configure the card as DID, assign target line 157 to extension 222. Then I configure target line 157 to receive 4 digits (1234). Then I go with my buttset on a DID trunk and dial 1234. I do not get any ringback, I do not hear anything and the phone does not ring. I can hear the DID card click when I go off hook with the buttset.

What am I doing wrong?

 

[sprucegrover]

Just did this in the lab with a R6.0 and 7 digits. The only issue was disabling and re-enabling the card before it would work, even though it already saw the card as DID. All the other settings were the same as yours and it worked perfectly from trunk port to set. Just make sure the trunks are set to tone

 

[jsaad]

yes, it was that the card was not 'seen' by the ksu. had to disable and then enable. thanks.
it's always something.