Hello everyone. I am working with a KX-TA 824 Hybrid System and am using the KX-TA Maintenance Console to program it. There are 3 CO's, and currently, if no lines are being used, they pick up in the order of 3, 2, 1. I need to change that so it picks up in order 1, 2, 3. I can't seem to find the place in the maintenance console where I can do that. Anyone know where that setting is or know another solution? Thanks for your help!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
help tes824
- Thread starter ingy500
- Start date
- Thread starter
- #3
I provided a solution to this, it never worked?
it's was clear and straight forward
it's was clear and straight forward
- Thread starter
- #5
- Thread starter
- #7
See Line Preference - Outgoing.
This selects the line to be seized after going off-hook to make a call
Check prog. 2.3
This selects the line to be seized after going off-hook to make a call
Check prog. 2.3
Also you can save your time by plugging out the jacks and placing the lines in the order you would like them seized.
And that is the simple way
Let me know if its solved.
And that is the simple way
Let me know if its solved.
- Status